On this page we carry our 2″ wide foil backed tennis, pickleball or basketball court marking tape in 150 foot rolls. Our 2″ x 150′ rolls run $59.99 each. We have both white and yellow. This tape performs well on asphalt, fully cured smooth cement, and aged painted surfaces. It is self adhesive, aluminum based and conformable to any surface. This product creates permanent or temporary tennis, basketball or pickle ball lines where the use of paint is not practical or desired. Can be removed if necessary.
Need tennis, pickleball or basketball court lines? Our tape is simple to install with no special equipment or contractor required. If the tape gets damaged it just takes a few minutes to replace the damaged piece. It is about as thick as normal court paint and has a durable, reflective surface. It can be removed if necessary. Longevity depends on wear level and proper installation. The tape performs best on smooth surfaces where all of the tape can make contact with the surface. The tape must be pressed onto the surface VERY well for it to perform properly. A rubber tired dolly with weight on it is often sufficient. Multiple passes are normally necessary. For large projects we suggest you install a roll of the tape first to determine if it will meet your requirements. . It is always recommended that you test a small piece of the tape on your surface before applying larger amounts. There is no warranty or refunds on this product.
INSTRUCTIONS – To install our pavement/floor striping tape simply apply it to a clean, dry surface and press it on so that it completely conforms to the surface. The temperature should be in excess of 50 degrees. Dry, clean, sun warmed asphalt or cement is ideal. Best adhesion can be achieved by going over the tape with a heavy rubber tire (dolly) roller or by using your vehicle tire. When using a vehicle be careful not to turn the steering wheel while on the fresh tape. Also, avoid applying the tape to damp asphalt or cement. Also, it is best to apply when it has not rained in 48 hours. After application the tape is ready for use, however, full curing occurs after about 48 hours and it is best if it does not rain during this time as well. I recommend you apply the tape and press it in VERY well. Then after 24 – 48 hours press it in again. It is always recommended that you test a couple of pieces on the surface you are going to mark and leave them down for a day or so. (We have tested this product with good results on smooth to relatively smooth fully cured cement and asphalt surfaces, painted surfaces where the paint is fully cured and aged, steel surfaces, and smooth wood surfaces after priming with contact cement.)
NOTE – IT IS VERY IMPORTANT THAT THIS TAPE BE PRESSED ONTO THE SURFACE WITH ENOUGH PRESSURE TO CONFORM IT 100% TO THE SURFACE. OTHERWISE THE TAPE WILL COME BACK UP. ALL EDGES NEED TO BE COMPLETELY ADHERED TO THE SURFACE. SINCE WE HAVE NO CONTROL OVER THE SURFACE THE TAPE IS APPLIED TO AND THE APPLICATION METHOD THERE ARE NO REFUNDS OR WARRANTY ON THIS PRODUCT.